< Back
  
MAINTENANCE
Carb Adjustment 


RECOMMENDED TOOLS

To adjust and service the Bladez MOBY Power Board you will need the following

tools:

! Allen Wrenches: 3 / 4 / 5 / 6mm.

! Wrenches: 10 / 13 / 16 mm Open and ring combination.

! Short reach Spark Plug Socket

! Large Adjustable Crescent Wrench

! Spark Plug Sockets

! Philips Head Screwdrivers

! Oil, Grease or Lubricant (such as WD-40)

CARBURETOR ADJUSTMENT

WARNING!

Never start the engine without the complete clutch cover assembled!

Otherwise the clutch can come loose and cause personal injuries.

In the Carburetor, fuel is mixed with air. When the engine is test run at

the factory, the Carburetor is basically adjusted. A further adjustment

may be required from time to time, depending on climate and altitude.

The Carburetor has only one possible adjustment:

T= idle speed adjustment screw


     

 
 
 

Idle Speed Adjustment

When the idle speed is adjusted properly, the engine will run smoothly, without pressing the THROTTLE LEVER.

If adjustment is required:

1. Start the engine.

2. Using a long, Philips head screwdriver

gently close (clockwise) the T-screw

until the MOBY starts to move forward.

3. Then open (counter-clockwise) the

screw until the MOBY stops.

4. You have reached the correct idle speed

when the engine runs smoothly below

the RPM when the MOBY starts to

move.

Note: Standard idle RPM is about 2500-

3000 RPM.

WARNING!

When the engine is idling, under no circumstances should your MOBY

be moving.

If the MOBY continues to move after idle speed adjustment, contact

Bladez or your local Bladez service center.
 

ShopFactory (TM). Click Here.