Rocket Key 
blrk
HALF PRICE!!!
rockit key

GO FAST PARTS!

1) Remove fan cover, leaving pull start attached
2) Remove flywheel nut
3) Thread the 6mm puller bolt into one of the threaded holes in the flywheel
4) Tighten bolt against case behind flywheel(look for high spot on case) until flywheel pops off
5) Remove stock woodruff key from crankshaft
6) Wipe end of crankshaft clean
7) Apply a small amount of grease to crankshaft end and keyway
8) Install the Rockit Key with the offset on the right side - rear
9) Re-install flywheel, lining up the keyway in the flywheel with the Rockit Key
10) Press flywheel on as far as possible by hand, it may be tight going onto Rockit Key
11) Install flywheel nut and tighten
12) Re-install fan cover
13) Re-check flywheel nut after first 5 minutes of use

Weight: 1.00 lbs